Elec Eng Asst
The Electronic Combat Solutions (ECS) business area is seeking experienced engineering electronics technicians to work in a dynamic engineering lab and/or operations environment. Depending on experience and skillset, opportunities exist to support complex digital circuit board testing and/or RF/microwave testing and associated tasks.
Must have extensive experience testing and debugging complex digital, analog and/or RF circuit card assemblies and modules. Must be able to isolate failures down to the subassembly and component level. Must be able to support non-routine testing and manually setup and operate a variety of standard lab equipment (power supplies, oscilloscopes, signal generators, spectrum analyzers, PNA, etc).
For RF skillset, familiarity with test methods and test equipment for performing the following tests is highly preferred: S Parameters, Gain, VSWR, Noise Figure, Gain Compression, Intercept Points, Spurious, Switching Speeds, Isolation.
Performs a wide variety of complex assignments including the planning, layout, test, troubleshooting, modification and repair of complex precision electronic subsystems or systems. Works under the general direction of engineering personnel in a research, design/development environment.
Performs a variety of complex functional and operational tests on developmental electronic systems, subsystems and assemblies in accordance with generally established procedures and data sheets.
Constructs, modifies and improves electronic circuits and designs including, but not limited to, power supplies and analog and digital circuitry, etc., utilizing basic electronic design techniques.
Troubleshoots, debugs, tests and performs precision measurements on a variety of electronic assemblies, systems and instruments, effectively utilizing equipment such as oscilloscopes, audio amplifiers, standing wave amplifiers, multimeters, phase sensitive demodulators, volt-ohm-millimeters, AF and RF signal generators, logic analyzers, watt meters, wave meters, phase measuring equipment, thermocouple and balometer power bridges. Utilizes computer aided design tools as required.
Sets up and operates a wide variety of testing equipment, improvising hook-up and equipment modifications as necessary to test, adjust, align, calibrate and modify circuitry, components, systems or subsystems, ensuring consistency with company and customer design specifications and performance requirements.
Works from schematics, diagrams, sketches and oral instructions to construct experimental or prototype models to meet engineering requirements. Utilizes conceptual drawing to design cable and harness assemblies for prototype electronic products and provides the necessary documentation to support the assemblies when released to production.
Develops and/or prepares schematics, designs, specifications, parts lists, etc.
Compiles, computes, analyzes, interprets and presents a wide variety of engineering data as required.
Previews designs or specifications for completeness, accuracy, adequacy and compliance with company and/or customer specifications.
Provides technical direction to less senior technicians.
- Performs other duties and responsibilities as required.
Meet Some of BAE Systems's Employees
Human Resources Manager
Melissa advises BAE Systems on the full HR spectrum. She brings in new talent, prepares team members for success, pops in on payroll and benefits, and shapes the company’s culture.
Back to top